We've sent a verification link by email
Didn't receive the email? Check your Spam folder, it may have been caught by a filter. If you still don't see it, you can resend the verification email.
Part 2 in a 6 part series testing different Mid-Side recording setups. All recordings in this series were done with a Sound Devices 302 field mixer to a Sound Devices 702 recorder. Mixer gain set at +60dB and fader level at +7.5dB across all mic configurations. Mixer - recorder line up was done at full scale. No low cut filtering was set on either device. Recordings matrixed to L-R stereo at the mixer stage. The differences between recordings are subtle and become more obvious through analyzers. Interesting things to look at are frequency spectrum, stereo correlation and peak and RMS levels. Recordings were done sequentially meaning one setup after the other. sample presented here were cut from the original recordings to get more or less equal soundscapes to make comparing easier. Recordings are presented here unmodified. Part 2: Mid-Side +Mid setup: Pearl MSH-10 single point MS microphone + low pass filtered DPA 4060 omni. Low pass filtering at 40hz was done before the mixer input. This third channel is mixed in panned mid in addition to the middle and side channels. This is a setup I thought up to compensate for the lack of low frequency response of cardioid and figure eight microphones.
Type
Wave (.wav)
Duration
1:00.889
File size
17.0 MB
Sample rate
48000.0 Hz
Bit depth
24 bit
Channels
Stereo
14 years, 11 months ago
Your work is beautiful. May I ask where the suburban and lakeside recordings were made?