We've sent a verification link by email
Didn't receive the email? Check your Spam folder, it may have been caught by a filter. If you still don't see it, you can resend the verification email.
I have built a Nonlinearcircuits Sloth LFO, the regular version. Sloth is a chaotic LFO. The output is based on the Lorenz system. It is a system of ordinary differential equations. It is notable for having chaotic solutions for certain parameter values and initial conditions. In particular, the Lorenz attractor is a set of chaotic solutions of the Lorenz system which, when plotted, resemble a butterfly or figure eight (very much from Wikipedia).
The Sloth has two outputs X and Y. Think of them as coordinate pairs. The output will probably never repeat itself but there is a pattern.
I have built the regular Sloth it usually takes approx 15 seconds to make a rough figure 8, one cycle in the “butterly”.
The knob changes the chaotic pattern. At some settings the signals will spend more time in one strange attractor than the other.
Now I’m testing the module in different ways. In this sound I have connected white noise to a filter. The filter frequency is controlled by Sloth (X output). In this patch I have set the initial frequency at 12 o'clock... The output sound from filter goes to reverb.
Type
Wave (.wav)
Duration
11:55.023
File size
120.3 MB
Sample rate
44100.0 Hz
Bit depth
16 bit
Channels
Stereo
7 years, 4 months ago
i use this
7 years, 4 months ago
@Gelb Hmmm good idea. I should use two filters.
@AlienXXX Thx :-) It works doesent it.
7 years, 4 months ago
cool.) u'd make this poly
7 years, 4 months ago
A good synthesized wind effect.