Tibetan chant played at half speed. This creates a very low pitched grating sound that can't be heard at normal speed. This is most likely a result of …
R
Razzvio
September 15th, 2009
September 15th, 2009
Tibetan chant played in reverse. Interestingly it doesn't deviate too much from the original sound, meaning that the sound is fairly pure and sinusoidal. Original recording can be …
R
Razzvio
September 15th, 2009
September 15th, 2009
Tibetan chant run through a high pass filter to emphasize the higher register harmonics of the throat singing. Sound has a very similar characteristic to the unmodified track, …
R
Razzvio
September 15th, 2009
September 15th, 2009
A welding torch heating the edge of a steel plate. This sample has more of the actual noise the torch is making rather than the noise coming from …
R
Razzvio
September 14th, 2009
September 14th, 2009
A welding torch heating the edge of a steel plate. The torch sent out a great deal of sparks due to the proximity to the plate edge where …
R
Razzvio
September 14th, 2009
September 14th, 2009
Sifting through a box of 2 inch bolts in a tool kit. The bolts were fairly thick and I was searching through just one box of them by …
R
Razzvio
September 14th, 2009
September 14th, 2009
A rotating metal fan that is part of an art piece. The fan was very jagged and heavy and had a lot of grease applied to it to …
R
Razzvio
September 14th, 2009
September 14th, 2009
Hand rolling metal rolling pins in a conveyor belt. Tried to get as many of the pins rolling as fast as possible to create a grating moving sound.
R
Razzvio
September 14th, 2009
September 14th, 2009
An old automatic piano like those found in saloons or entertainment facilities circa 1940s. Part of a collection at Musee Mechanique in San Francisco, operates on quarters and …
R
Razzvio
September 14th, 2009
September 14th, 2009
The sound of a metal chair/ short steps screeching around the ground. I leaned my weight on it and pushed down and forwards to get a good loud …
R
Razzvio
September 14th, 2009
September 14th, 2009
Flexing a 3ft by 5ft piece of sheet metal back and forth along the ground to get a ringing rasping quality when shaken fast enough. The metal sheet …
R
Razzvio
September 14th, 2009
September 14th, 2009
Banging on a large metal sheet. Metal is most likely steel or a composite sheet metal. Fairly thin and flexible measured approximately 3 ft by 5 ft.
R
Razzvio
September 14th, 2009
September 14th, 2009
An old fashioned, touch-tone, large receiver telephone with a mechanical bell ringer. The bell has an arm attached to it that vibrates when a call is made. The …
R
Razzvio
September 14th, 2009
September 14th, 2009
This recording was done at Trampa canyon in the Carmel valley around 11pm. There are mostly cricket noises, a few planes fly overhead and there is a faint …
R
Razzvio
September 14th, 2009
September 14th, 2009
This is a modified recording of a woman's voice talking in a classroom setting about the daily reading. The voice was changed by decreasing the speed by about …
R
Razzvio
September 14th, 2009
September 14th, 2009